Support Center

Block a Portion of a Road

Last Updated: Nov 13, 2017 12:28PM EST
To learn more about Road Editing please see What is Road Editing?

Our Road Editor allows you to Block stretches of road so that WorkWave Route Manager will avoid planning for Vehicles to use that road. 

1. Click the Settings gear in Route Manager.

2. Click on "Road Editor".

3. Find the road on your map that you want to edit.

4. Click "Draw New Segment".

5. Left-click on the starting point for your Block (your map may zoom in to make it easier for you to draw).

The length of the segment must be between 20 and 650 in length (more than enough to cover most roads). The instruction box will be red when the length is below 20 and more than 650.

6. Left-click where you want the Block to end (the other side of the road).

7. Name the Segment.

8. Check Block if you want to make sure your Vehicles do not pass through the Segment.

9. Click "Done".

10. Repeat at the other end of the road.

11. Click "Save Changes".

12. Click "Apply Now" to save your changes.

Related Topics
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found